Sump Pump Accessories
|
Earth Contact Products (ECP) offers many accessories for sump pump and drainage systems. From sump pump switches, sump floats, pump stands to batteries and drain systems. Our products are all carefully selected to provide owners with the very best in waterproofing protection.
|
 |
|
The ECP sump switch is a twin float controller for primary sump pumps. This switch directly replaces all varieties of float switches, including vertical, tethered and pressure. This simple plug and play system gives you the protection of two switches in one unit. The DFC2 switch begins the pumping cycle when the float rises and it runs the pump an additional 10 seconds after the float returns to its original position. This switch also has an audible and visual alarm if any problems are detected by the system |
|
 |
|
The ECP BSPS pump stand is a rigid base that provides a platform for sump pumps, keeping them away from sump pit debris. By insuring that the sump pump does not pickup debris off the bottom of sump basins, sump pump impellors and check vales will last longer. |
|
 |
|
The ECP SWCV 150 check valves are designed to provide years of service. Their heavy duty design stops water from falling back into sump basins after the pump has stop pumping. ECP encourages the use of “silent” spring loaded check valves to eliminate the sump pump “clunk” after pumping cycles. |
|
 |
|
ECP offers a complete lineup of backup sump pump batteries. From maintenance free units to acid filled batteries, ECP can match the correct battery to the correct sump pump. Not all batteries are made the same and typical deep cycle batteries are not designed for basement sump pump applications. You should only use battery systems that are designed for sump pump duties.
|
|
 |
|
The ECP Battery Box is a molded polyethylene container designed to hold backup batteries for sump pumps. The specially designed box can accommodate up to two batteries keeping wires hidden and providing a finished appearance to any sump pump job. |
|
 |
|
Minimize the risk of water damage with an ECP Water Alarm. This portable unit can be installed anywhere there is a threat of water leaks. Whether it is in a utility room, laundry room, next to a floor drain or sump pump or even near a kids toilet, the ECP water alarm will detect the presence of water and give an audible alarm before leaks can become a larger problem. The unit runs on a typical 9 volt battery and can detect as little as 1/32” of water. With a six foot sensor wire installation is easy just about anywhere. |
|
 |
|
The ECP Freeze Guard is a simple device designed to eliminate problems when sump pump discharge line freeze. The ECP Freeze Guard is installed outside the basement in line with the discharge pipe. If extreme temperatures freeze the discharge line your sump pump will still be able to expel water without worry of damaging the system. |
|
|
